The versatility of Pneumatic high stress grouting pumps

Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the free rock mass. The most grain measurement can’t exceed 0.2 mm.
Grouting pump operation and maintenance is easy, protected and dependable. This pump is utilized in mines operating under difficult conditions because it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump include: An air inlet, the pneumatic cylinder, mounting base body and stand, strain gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How it really works
Pneumatic stress in the air cylinder exerts a high stress on the grout mixture which ends up in ejection of grout with a excessive strain and velocity. The valves of the air cylinder within the pump operate mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump may be driven even with out Electrical power supply in remote areas by utilizing engine pushed compressor.
The pump is majorly used in construction and mining industry for injecting materials into extensive and medium dimension gap in beams, columns ,basement partitions and flooring, carry shaft concrete wall fill-up and so forth. In mining industry it’s used to replenish cement resolution the place there is a hole exists between structure and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is extensively used in tunnels, coal mine, bridges and dams, constructing foundation, and different underground projects, and inflammable, explosive sites and different bad environment.
It has application in chemical industry also to pump out chemical slurries.
The pump is electricity free so, can be used at any site situation whether it is rural or city.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment vary. Generally the final quantity of the grouting quantity is 8 or10 instances of the quantity at first. And the ultimate grouting amount proves that filling is compacted.
Simply put; Official -pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and circulate may be adjusted based on the requirements of grouting,(The move of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is especially used for highways, railways, water and electrical energy, construction, mining etc. ground/underground construction.
Mining Pneumatic Grouting pump has the benefits of low power consumption, small vibration, low noise, small size, high efficiency, reliable efficiency, stress and move control, lengthy life and so forth. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Authority can be Light weight and with a wheelie design it might be carried simply. It is designed for straightforward operation and low maintenance. Last however not least its spare components are simply out there.

Leave a Comment